uclibc/arm: doesn't build in thumb(1) mode with threads

It runs out of registers, it fails even in official form
(COMPILE_IN_THUMB_MODE=y) so just build it in ARM mode since EABI
mandates interworking.
Tested in an arm920t board.

Signed-off-by: Gustavo Zacarias <gustavo@zacarias.com.ar>
Signed-off-by: Peter Korsgaard <jacmet@sunsite.dk>

package/uclibc/Config.in

@@ -185,7 +185,7 @@ config BR2_UCLIBC_ARM_TYPE
 config BR2_UCLIBC_ARM_BX
 	bool
 	depends on BR2_UCLIBC_TARGET_ARCH = "arm"
-	default y if !BR2_fa265 && !BR2_strongarm
+	default y if (BR2_ARM_CPU_HAS_THUMB || BR2_ARM_CPU_HAS_THUMB2)
 
 config BR2_UCLIBC_MIPS_ABI
 	string

package/uclibc/uclibc.mk

@@ -74,6 +74,11 @@ define UCLIBC_ARM_ABI_CONFIG
 	$(call UCLIBC_OPT_SET,CONFIG_ARM_EABI,y,$(@D))
 endef
 
+# Thumb build is broken with threads, build in ARM mode
+ifeq ($(BR2_ARM_INSTRUCTIONS_THUMB)$(BR2_TOOLCHAIN_HAS_THREADS),yy)
+UCLIBC_EXTRA_CFLAGS += -marm
+endif
+
 ifeq ($(BR2_UCLIBC_ARM_BX),y)
 define UCLIBC_ARM_BX_CONFIG
 	$(call UCLIBC_OPT_SET,USE_BX,y,$(@D))
@@ -348,7 +353,7 @@ endif
 UCLIBC_MAKE_FLAGS = \
 	ARCH="$(UCLIBC_TARGET_ARCH)" \
 	CROSS_COMPILE="$(TARGET_CROSS)" \
-	UCLIBC_EXTRA_CFLAGS="$(TARGET_ABI)" \
+	UCLIBC_EXTRA_CFLAGS="$(UCLIBC_EXTRA_CFLAGS) $(TARGET_ABI)" \
 	HOSTCC="$(HOSTCC)"
 
 define UCLIBC_SETUP_DOT_CONFIG